Day one with the radios: the calibration lives in the FRAM
Two used RT95s arrived today and both were backed up over the stock cable within the hour. The protocol on the mic jack is the one the factory software speaks: a handshake, then 16-byte reads and writes of the radio's 16 kB FRAM. The factory software only ever reads the first 12.8 kB. The interesting part is above that.
- The top of the FRAM is the transmitter calibration. Three 39-point tables for VHF (136 to 174 MHz in 1 MHz steps, one per power level) and 91-point tables for UHF (400 to 490 MHz), which are the power-amplifier correction curves. Then the calibration frequencies (156.125 MHz for VHF, 446.125 for UHF, plus the band edges) and the two calibration blocks: frequency trim, PA drive per power level, modulation and tone deviation, squelch thresholds, RSSI reference.
- It is per unit. The two radios have identical firmware and identical tables of frequencies, but their calibration blocks differ by a few counts and 39 bytes of the PA curves differ. Nobody types these in; they come from the factory tuning jig.
- So a Full backup is a calibration backup. No other tool for this radio saves it. If a future tuning experiment goes wrong, the fix is to write the block back. Rigbench's Raw tab draws the curves and names every field, and never writes to that region.
- The first write went through today. One channel renamed on the second radio, one 16-byte block written, read back in the same session, restored, and read again from a fresh session. Writes are now on for the RT95 in the public build.
- One more thing on the mic jack. Outside of programming sessions the control head streams a short status frame whenever something changes: which side is active, whether the transmitter is keyed, and whether the squelch is open. That last bit is a carrier-detect signal on a jack every RT95 already has, with no hardware modification. More on that when it has been exercised properly.
Next: a dummy load is on order, which unlocks the PTT command and the first calibration write test. A separation kit is on the way from Australia, which is the easy route to the internal ribbon connector and the first logic-analyzer capture of the head-to-body protocol.